Technical & Reference Section > Tech and Restoration

Nightmare spindle bolt on profile cranks help

(1/2) > >>

martylaa:
Ok pulling apart a set of gen 3 profile cranks however the bolt holding on the profile spider to the arm is seized solid, soaked in wd40 astill no good any ideas or should i get the deadly drill warmed up
wanna send the cranks away for chroming today aaahhhhh :2gunsfiring_v1:

diesel:
have you tried to tighten them half a turn - sometimes does the trick

martylaa:
tried all the above, jeses think hercules must of tightened this mother up :LolLolLolLol:
sod it sending it down to the chromers hopefully they can get it out, theres been a few tools getting thrown at my garage walls this morning and some expletives been used i can tell ya's :tickedoff:

DIRTBIKER250F:
Is it my chromers your sending them to Marty ? if so Dave an his Bro are mx'rs and trials specialists so give em a ring and let them know the issues, am sure they will bang it out  :LolLolLolLol:

GTnumber1:
warm it up and get some molgrips on it thats what i had to do on siezed set of cranks and it came out  :daumenhoch:

Navigation

[0] Message Index

[#] Next page