Technical & Reference Section > Tech and Restoration
MRD built 4 MK10 just thought peeps might wanna know b4 MK11 its story
animal:
Was defo a National Pro I remember the thread ;) All the main tubes were eaten away from the inside and looked like swiss cheese >:(
animal:
Started the long hard haul with this project . Couple of hours of prep work and I'm ready 2 have ago at braizing the seatpost tube back on 2 the bottom bracket ;)
Next job after that is seatpost out ::) Can't do it at the mo cos the frame is 2 flexy >:(
fischflo:
..........looking good :angel:
.................
animal:
Right here's how I got on with the braizing ::) Had a few practice runs and decided I was probably going 2 toss it up :LolLolLolLol: so I defered 2 using Tig and phosphur bronze rods ;) think the result is pretty close 2 the original and I'm chuffed 2 bits with the result :smitten:
Now I might be able 2 get the seatpost out with out twisting the frame :-X
While I was at it I filled up the extra holes in the forks some Numptie had drilled 2 fit a MX1000 brake :uglystupid2: Bit of fettling and no body will tell :daumenhoch:
stevochb:
Nice job :daumenhoch: Im sure it will turn out all good in the end.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version