Technical & Reference Section > Tech and Restoration

acs rotor

<< < (3/4) > >>

Rombloke:
the only problem with oddy gyros or any gyro come to that is the cut out on the back of the bottom plate(the one that sits under your top bearing cup) isnt quite wide enough for a twin top tube bike.
will fit a sport lovely, but on a master you need to dremmel the back of the plat out to allow it to seat properly other wise it hits the tubes and knocks shells of paint out each side.

hope this helps

Dave

Stevo:
Thanks for the advice Rom Bloke.

Good job you pointed this out before went out attempted to fit on the Master.

Not sure I will fit a gyro or a rotor now. The new 2006 Sport come with one, so I will use that bike for tricks that need a gyro. Cheers

theRuler:
believe it or not a properly set up gyro is more effective than a regular cable.

billstup:
Not better than an oddy slick cable though  :daumenhoch:

theRuler:
better than any single cable

Navigation

[0] Message Index

[#] Next page

[*] Previous page