Technical & Reference Section > Tech and Restoration

OPC pedal thread advice

<< < (2/3) > >>

jT Racing:
they can be a proper cnut to get out when they rusted in proper. :-\

double chevron:

--- Quote from: mark j. on June 01, 2010, 10:32 AM ---When I'm lost on shit  like that, I just go to another bike thats loose and try them out

--- End quote ---


We're doomed if even a DJ doesn't wich way round things must go  :LolLolLolLol:

moley:
The same as a 3pc.

If your standing over the bike (sat on it).  Stick your wrench on the pedal and pull toward you from the top.  Same as the other side (because threads are reverse).   Loosen by unwinding to the rear.  Tighten by winding to the front.    Piccys in the guides below will help!!  :daumenhoch:


Guides and tips :-

http://www.parktool.com/repair/readhowto.asp?id=83

http://www.jimlangley.net/wrench/pedalbasics.html

Leverage is the most important thing.   Using a stubby spanner wont get you nowhere.  A good pedal wrench with a long handle is far better.

dordymush:
a BIG fook off hammer  :crazy2:

daz bmx it!:

--- Quote from: dordymush on June 01, 2010, 01:55 PM ---a BIG fook off hammer  :crazy2:

--- End quote ---

 :LolLolLolLol: do you not think this was my first option Dave?  :2funny:

Navigation

[0] Message Index

[#] Next page

[*] Previous page