Technical & Reference Section > Tech and Restoration

Ody Driver fitting

(1/1)

Stella Dave:
Took my Ody 10t driver off to remove the grease I'd put in as it was sticking a wee bit.

When putting it back in and the nut on hand tight the driver is very stiff! As soon as it tightens it goes against the rubber seals and gets stiff.

Cant see any other way to put it in but I dont rem it being that stiff before.

Any fitting guides please??

Gary72:
Is there a collar that you have left out?
Goes between the bearings in the hub and the bearings in the driver.

Bettyswallocks:
What hub is it dude?

Odyssey have some instructions online

http://www.odysseybmx.com/techcorner/

Stella Dave:
It's a 1 piece for use with Hazard Cassette.

The axle has a step in it so it only goes in so far. I think I have to get the distance just right with the seal using the opposite axle nut??

Navigation

[0] Message Index