Technical & Reference Section > Tech and Restoration

A Nightmare with the Oven Pride - finsihed pics of top of stem

<< < (4/5) > >>

Jamroll:

--- Quote from: Southern Andy on June 13, 2010, 08:10 PM ---A quick rub down and then the polish should sort it.

--- End quote ---

A quick rub down eh.... :2funny:
7 and a half hours just to sort out the top of the stem,
400 grit wasn't cutting it  :( so used a bit of emery cloth to begin, then battered the bastard with 400  to get rid of the pitting and then 800.
Only the 1200 and 1,500 to go and then off for a polish.
Here it is as of now. Will get polished by the weekend :daumenhoch:

brettypeeps:
How that is more like it.  Great work :daumenhoch:

ozone:
Looking good.  A bit of a file will remove those hammer and spanner marks then you'll have to get some 180 grit on the blighter to remove the file marks before moving on to the 400.    This will save your elbow a bit.  ;)

bobafett:

Looking a lot better  :LolLolLolLol:

PM "Steve P" about how to get the original "brushed" look back  ;)

Jamroll:
Ok got a couple of pics, should have put these up at the weekend, but been dealin with a pregnant wife and the death of my cat  :'(
looking a lot better now :daumenhoch:




Got a little way into the bottom half of the stem.



Also gonna try and clean up some rear pegs off a CW cali Boulevard...these we rusty as fook.

Navigation

[0] Message Index

[#] Next page

[*] Previous page