Technical & Reference Section > Tech and Restoration

A Nightmare with the Oven Pride - finsihed pics of top of stem

<< < (2/5) > >>

Rodgy1970:
If it was mine I'd try keep the machined finish as much as possible, you can still see it in the first pic through the oxidisation, maybe use some fine grade wire wool or even autosol.

Jamroll:
I'll give the Autosol a go first and then move on the wirewool.
Nice one :daumenhoch:

mark 2:
One of them green scotch pads that birds do the dishes will get the black off

meticulous:
it looks more than a quick polish to me,

 oven cleaner eats into the alloy, pitting the ally,

 you are going to have to sand down with wet n dry first to get through all the pitting so get a smooth finish, which could also make the logo go faint, unless you are going to powder coat it its the only way to get a decent finish...

start with 400's preferably on a block because its a flat surface,use soapy water, then finish on 1000's or 1200 (very soft wet n dry)

sam

Redline:

--- Quote from: mark j. on June 13, 2010, 09:02 PM ---One of them green scotch pads that birds do the dishes will get the black off

--- End quote ---

 :LolLolLolLol: :LolLolLolLol:  .... green scotch pads that birds do the dishes with  pmsl

Navigation

[0] Message Index

[#] Next page

[*] Previous page