Technical & Reference Section > Tech and Restoration

Stuck spocket nut

<< < (2/3) > >>

skki3330:
Thats what i done to start with and the spokes started to bend the rim soooo i stopped.
Yeah can run it done my local bike rip off merchants lol.

brettypeeps:
OOOHH lah angle grinder time then I reckon on that but take your time not to damage the hub and wear some goggles as the bearings can come out at some pace.  give it a good soak in 3 in 1 oil or WD40 while doing it to keep the temperature down :daumenhoch:

oldtired:
get the toothy woothy bit off, inside there'll be a couple of dinty winty's where the pawly wallie or ratchety cratchety bit fits , use something that fits the dint winty you should be able to loosen it with a good shocky woky , i don't mean show it the twig and berries either, :LolLolLolLol: , load of wd40 and a heavy hammer bammer , anti clock wise with the freewheel  facy wacying you  , if it don't budgie wudgie after that then your fooktie wookty  :LolLolLolLol:

brettypeeps:

--- Quote from: oldtired on July 05, 2010, 10:28 PM ---get the toothy woothy bit off, inside there'll be a couple of dinty winty's where the pawly wallie or ratchety cratchety bit fits , use something that fits the dint winty you should be able to loosen it with a good shocky woky , i don't mean show it the twig and berries either, :LolLolLolLol: , load of wd40 and a heavy hammer bammer , anti clock wise with the freewheel  facy wacying you  , if it don't budgie wudgie after that then your fooktie wookty  :LolLolLolLol:

--- End quote ---
:LolLolLolLol: :LolLolLolLol: :LolLolLolLol: :LolLolLolLol:

skki3330:
 :LolLolLolLol: :LolLolLolLol: :LolLolLolLol: :LolLolLolLol: :LolLolLolLol:

Taking down the biky wiky shop tomorrow done my heady weady in!

Navigation

[0] Message Index

[#] Next page

[*] Previous page