Technical & Reference Section > Tech and Restoration

Bit of crank help please.

<< < (3/5) > >>

THIRSTYKIRSTY:
your spacer in the frame inbetween the bearings is a shade to long

run as is ,,it will be fine

southern andy:

--- Quote from: MADD  DOGG on July 21, 2010, 09:37 PM ---your spacer in the frame inbetween the bearings is a shade to long

run as is ,,it will be fine

--- End quote ---

I thought that so i put the short one in, can i run it without a spacer ?????????






--- Quote from: mattfx81 on July 21, 2010, 09:32 PM ---Just going to hijack your thread andy whilst we are on about crankage... I have a redline flight crank with a dk us bb on my bike at the moment, can i put my profile crank on that bike using that same bb or do I need a dedicated profile bb?

Matt

--- End quote ---

Any US BB should work Matt but then what do i know about cranks.   :LolLolLolLol: should be fine to use mate.

pickle:

--- Quote from: mattfx81 on July 21, 2010, 09:32 PM ---Just going to hijack your thread andy whilst we are on about crankage... I have a redline flight crank with a dk us bb on my bike at the moment, can i put my profile crank on that bike using that same bb or do I need a dedicated profile bb?

Matt

--- End quote ---

It will be fine mate, both cranks use 19mm axle so the DK BB is fine  :daumenhoch:

mattfx81:
Cheers andy, just spoken to James(voivod) and he reckons it will work and he is in the know so its spanners out time...

Matt

HUTCHMAN:

--- Quote from: Southern Andy on July 21, 2010, 09:42 PM ---
--- Quote from: MADD  DOGG on July 21, 2010, 09:37 PM ---your spacer in the frame inbetween the bearings is a shade to long

run as is ,,it will be fine

--- End quote ---

I thought that so i put the short one in, can i run it without a spacer ?????????






--- Quote from: mattfx81 on July 21, 2010, 09:32 PM ---Just going to hijack your thread andy whilst we are on about crankage... I have a redline flight crank with a dk us bb on my bike at the moment, can i put my profile crank on that bike using that same bb or do I need a dedicated profile bb?

Matt

--- End quote ---

Any US BB should work Matt but then what do i know about cranks.   :LolLolLolLol: should be fine to use mate.

--- End quote ---



if you don't use the spacer,it will side load the bearings and will run tighter than a ducks ass!

Navigation

[0] Message Index

[#] Next page

[*] Previous page