Technical & Reference Section > Tech and Restoration

craqnks can be pain sometimes

(1/2) > >>

motomagII:
right fitted set 3 piece cranks new school jobbies with unsealed bb set got em running smooth as butter .but the bolt that hold the chaintring in place is catching on the bb cup .so removed them and added another spacer to bring the chainring out bit hey presto no rubbing but the chain is out of line with the freewheel .????
does the chainring make type effect this or is it just leave the chainring bit further out so chain alignment isnt perfect .whichj then you can hear the noise it makes when pedalling as its rubbing on the freewheel sides and chainring sides of teeth not in middle

meticulous:
can you try another chain ring bolt or grind down the one you have a bit so it doesnt rub?

bof:
Just file the edge off the bolt . they are always real close on american BB's . the  bolt should be domed is  yours

HEYWOOD BMX:
 :) You can buy spacers to space out the freewheel,usually in 1mm increments for about 30p each.They are intended for Euro bbs but are exactly the same size as the threaded part of a freewheel.

Jon The Bassist:
The type of chainwheel shouldn't affect how much the bolt protrudes (much). As said before, the bolt should be very domed on the head. On my Felt Cruiser that bolt is barely 1mm from the BB, with a very good chainline. Shame the cranks are buggered where they fit the splines  :crazy2:

Navigation

[0] Message Index

[#] Next page