Technical & Reference Section > Tech and Restoration

Think I might have screwed up :-(

<< < (2/2)

g_lamb:

--- Quote from: pickle on July 26, 2010, 07:53 AM ---have fun, where you off to? 

--- End quote ---

Thanks dude

Richworth Linear Fisheries over @ Oxford. Am hoping to catch a 30lb'er this week!

The misses is OK with me disappearing for a few days too  :daumenhoch: Suppose she gets a rest from me  ;D

Right. Best start packing the motor. See you in a few days m8

Spen69:
Bring them to the big green gazeebo by the helipad and we'll have a look for you. Got a set of bearing pullers but they will only get the bearings out the cups, you will still need to knock the cups out which we can also do. The bearings may be very slightly tapered for fitting so we can check.

Spen

calmac:
I find putting the bearings in the freezer overnight,then grease before knocking them in works a treat,used to do this on my motocross swingarm bearings as they were a right bitch,did it recently on my Zippo as i upgraded to a 3 piece crank & damaged one bearing before remembering this method.
After putting the bearing in the freezer it knocked in fairly easy.

Cheers, Calum 

Navigation

[0] Message Index

[*] Previous page