Technical & Reference Section > Tech and Restoration
HAS ANYBODY TRIED TO GET A STEM RE'ENGRAVED ????
pickle:
What did you buy one of those polished ones? ;D
rollin72:
this seems to be a bit of a problem,ive tried several places and all have said no, it seems its down to the software they use not being able to copy logos ???
going to try tinternet and see if someone somewhere has the correct software
In2 bmx:
just bring it in mine mate ... With a photo of the logo we can re-draw it for you ......... then you can take it to anyone... unless you want me to try with my 8' x 4' router :LolLolLolLol:
Gary72:
--- Quote from: rollin72 on August 24, 2010, 06:47 PM ---this seems to be a bit of a problem,ive tried several places and all have said no, it seems its down to the software they use not being able to copy logos ???
going to try tinternet and see if someone somewhere has the correct software
--- End quote ---
'Computer says NO' :LolLolLolLol:
Need to find a genuine engraver not a computer operator, Good Luck
In2 bmx:
Well i had a play with my router today for Gaz and here is the results..... This is a big machine and can route 8' x 4' sheets easily ... This was done without even putting the engaving head on ... It could be better, but a great start.. Just 0.3 of a mm to deep im thinking ....
This is how it started
Sanded the face clean
The Router
Ready to go
And the end result, it is very slightly to deep but the next one will be perfect....... Im going tho get the tuf neck tiger drawn up and see how it goes..
Not bad for the first go,but gaz is getting this powdered so it should look ok :daumenhoch:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version