Technical & Reference Section > Tech and Restoration

ding

(1/1)

scott250:
What would be the best way to fill a small ding in a main tube?  Its a painted ox tubing standard 250.  I'm guessing I should raw the lot, rough it up a bit and pop some kind of hot metal in the ding and file it till smooth ;D . I will probly ride it a bit, but I hear frames can flex a little so it might not work and fall off at some point, or is that just bollox  ;D.

Bigplinky:
You could try and pull the ding out if it isn't too sharp edged.

scott250:


its only small, you can just make it out on this pic.

Navigation

[0] Message Index