Technical & Reference Section > Tech and Restoration

mods we did bitd

<< < (5/9) > >>

mattfx81:
Spokey dokeys were well good! and the tony tiger reflectors that fitted between 2 spokes.

steve69:
I used to cut the centre tread out of a worn tyre and use it as heavy duty rim tape as i was getting so pi55ed off having to go home and repair punctures every time i landed a little bit sideways on my ACS Z-rims  :coolsmiley:

Redline:
I used an old number plate, a hacksaw and some heat on the gas hob to make a plastic cover for the "ugly" seat clamp set-up on my Skyway Freestyle Platform.

Then sent a pic to BMX Action Bike Magazine and it was featured in the letters column  :)

I aint got a copy of the mag though so if some one has a scan of it I'd like to see it after all this time  :daumenhoch:

ThisBitterPill:
We screwed Axle Nuts from my Mum's mini onto the ends of our rear axles for very early pegs

Despite my Dad's insistance that we would 'snap our spindles'....

 :laugh:

john4130:

--- Quote from: cheekythirtysix on September 14, 2010, 12:11 AM ---I used an old number plate, a hacksaw and some heat on the gas hob to make a plastic cover for the "ugly" seat clamp set-up on my Skyway Freestyle Platform.

Then sent a pic to BMX Action Bike Magazine and it was featured in the letters column  :)

I aint got a copy of the mag though so if some one has a scan of it I'd like to see it after all this time  :daumenhoch:

--- End quote ---
any idea what year? i may have it.

Navigation

[0] Message Index

[#] Next page

[*] Previous page