Technical & Reference Section > Tech and Restoration

Help with vector rear Tri Hub spacing

(1/2) > >>

FuNMoNsTeR:
Ok... I have an old school shimano hub and a suzue hub... both standard bmx spacing(110mm). The spacing on the rear triancle of the Vector Mark II is 95mm. I dont want to spread the rear tri and force a wheel in. If i take off both cone nuts each side it fits but the sprocket is then still hard up against the inside of the stay.... Does anyone have any clue what kind of Hub i will need to fit this bizarre spacing?

Mattdub:
Andy ,

bitd my Vector used Tuffs most of the time , I did though put my race wheels in it once & raced it at MK . If it helps the hubs were the billet (not later cast ?) GT hubs with allen bolt collars & hollow axles , similar to the one's Darren was selling a few days ago .

Shown below in both guises :




I'll measure my chainstay width tomorrow.

Matt

FuNMoNsTeR:
Thanks m8... that would be handy :daumenhoch:
 My frame is a NOS one...identical to the one in the bottom pic.

Mattdub:
Hey Andy ,

My rear chainstay/dropout width is 112mm .

Matt

FuNMoNsTeR:
:o :wtf:

Wow... Thanks for your time m8 :daumenhoch:
   My frame looks straight as an arrow...whats going on ???

Navigation

[0] Message Index

[#] Next page