Technical & Reference Section > Tech and Restoration

first build - pk ripper

(1/7) > >>

sharp767:
hi all,
ive been on the site for a month or so and its fantastic, i was going to try and stop at two bikes but now im in i think thats going to be impossible!, anyway here is my first build, its been a long time coming and there are still a few bits im not sure about, the brake pads for a start, and the tuffs, ive got a set of ukai blue/silversides which i could get built but im not sure if they would be correct?comments, compliments and constructive criticism please.. :)

Bettyswallocks:
Nice build dude...  :daumenhoch:

I'd prefer it with the ukai's though, and loose the front brake, its a race bike...  ;)

ozone:
I can't fault it personally but I'm sure someone will tell you to pull the bars back a bit so I'll save them the bother.  ;D

That square corner Tuf Neck is a beaut  :smitten: - was it NOS and where did you find it?

Sweet build IMO.  :daumenhoch: :4_17_5:

Just noticed that the rear blocks are struggling to reach the braking surface on the Tuffs.  Taking a link out of the chain should sort that or swap the MX900 for a 1000. (assuming they're 900s)

Rodgy1970:
very nice   :coolsmiley:

ozone:
The bike stand does spoil the pictures a bit so you might be better off using the Rad trick of resting the pedal on a pint glass.  Best done on the lawn in case it decides to fall over.  :daumenhoch:

PS.  Where's the snow?  :)

Navigation

[0] Message Index

[#] Next page