Technical & Reference Section > Tech and Restoration

Pedal fitting

<< < (4/4)

wildon:

--- Quote from: brummie on December 30, 2010, 08:44 PM ---are they original axles terry  :-\

--- End quote ---

I think so .. although the left is marked "L" and there is nothing on the right .. but they are identical otherwise

MartyC:
I'd see if you can run a tap threader over the pedal axles just to be sure that they are OK, if they have been plted over that would affect the thread pitch, re-tapping them might clear it  :daumenhoch:.

wildon:

--- Quote from: MartyC on December 31, 2010, 06:11 AM ---I'd see if you can run a tap threader over the pedal axles just to be sure that they are OK, if they have been plted over that would affect the thread pitch, re-tapping them might clear it  :daumenhoch:.

--- End quote ---

I think thats going to be my only option.  They are the og finish though, not plated .. and i've scrubbed them clean

MartyC:

--- Quote from: wildon on December 31, 2010, 10:38 AM ---
--- Quote from: MartyC on December 31, 2010, 06:11 AM ---I'd see if you can run a tap threader over the pedal axles just to be sure that they are OK, if they have been plted over that would affect the thread pitch, re-tapping them might clear it  :daumenhoch:.

--- End quote ---

I think thats going to be my only option.  They are the og finish though, not plated .. and i've scrubbed them clean

--- End quote ---

I'd deffo try and get them re-tapped then if they are OG finish in raw  :daumenhoch:

Navigation

[0] Message Index

[*] Previous page