Technical & Reference Section > Tech and Restoration

3 piece crank issue

(1/2) > >>

oldskooldayz:
Hi peeps little issue here

For some reason when i set up my cranks and chain wheel the chain wheel is off like on a wobble
I'm adding the shims but to no joy it still seems out

Any suggestions please

I've never had thus before

brettypeeps:
What cranks and what chainwheel fella.  Do you need a nineteen to 22mm adapter?

oldskooldayz:
new oldskool redline proline 180mm single pinch and no adaptor needed

im useing a power disc and 44 chainwheels

nosepickben:
I had this, used a combination of a shims on axle + drive bolt to get line right. Still not 100% but good enough for action.
Largeflat thin shim on spindle then what i think was a 10mm wheel axle washer as shim between drive bolt + crank arm. gave me spot on chain line + near enough dammit no sprocket wobble on crank arm. Took time tho bro and a lot of washer hunting+ modyfying with crappy file. good luck, you'll get there.

oldskooldayz:

--- Quote from: nosepickben on January 24, 2011, 08:30 PM ---I had this, used a combination of a shims on axle + drive bolt to get line right. Still not 100% but good enough for action.
Largeflat thin shim on spindle then what i think was a 10mm wheel axle washer as shim between drive bolt + crank arm. gave me spot on chain line + near enough dammit no sprocket wobble on crank arm. Took time tho bro and a lot of washer hunting+ modyfying with crappy file. good luck, you'll get there.

--- End quote ---

sounds like this is what i will have to do from your explanation

i might even just put a 1 piece in cause im a lazy fooker  :2funny:

no i will give it shot first and when it feels like im about to throw the bike out the window i will put the 1 piece on  :D

cheers

Navigation

[0] Message Index

[#] Next page