Technical & Reference Section > Tech and Restoration

Removing paint from Skyway's

<< < (2/4) > >>

skki3330:

--- Quote from: bmxbob on February 20, 2011, 04:24 PM ---ive used Nitromors on Skyways with no probs, not on the alloy hubs mind but its ok on the plastic.

i didnt leave it on too long, just till it started to bubble up.

took two or three coats to get thick hammerite off

Bob  8)

--- End quote ---

Reckon i might have to do that on one of them. How the hell did you got into the little gaps :D

trasher:
pm n2cus he can tell you  :LolLolLolLol:

firebird4130:
haven't tried this but got some wheels I plan on trying it out on

bigfatolly:
i stripped off an alloy hub rear and plastic front pair,they had household gloss on :LolLolLolLol:

used water based nitromors,stipple it on with a paintbrush small sections at a time.

as soon as it pickles take it off with wire wool,then do another section.

i used a flat head screwdriver to get in the awkward nooks and crannies.

keep going til its all off,takes a bit of time but worth it.

pickle:

--- Quote from: the gay pensioner on February 20, 2011, 04:49 PM ---pm n2cus he can tell you  :LolLolLolLol:

--- End quote ---
:LolLolLolLol:

Navigation

[0] Message Index

[#] Next page

[*] Previous page