Technical & Reference Section > Tech and Restoration

Oven Pride and anodizing question..

<< < (3/4) > >>

HARORIDER:
defo works better at room temp so leaving it in a shed or clod garage slows down it's performance :daumenhoch:

oldtired:
last time i saw a seat post like that it had a Team Murray at one end and a young kid attached at the other ,   Cantley track about 82 ish  ,    crappy plastic yellow seat snapped , mind you, mine did too but i only got ring ripper,     his was well in there  :-X    :shocked: :shocked:

ED209:

--- Quote from: harorider on February 22, 2011, 04:32 PM ---defo works better at room temp so leaving it in a shed or clod garage slows down it's performance :daumenhoch:

--- End quote ---

truth accepted.

I had it in the hoose for a couple of nights and warmed the seat post up as well ( see Snavs picture )  :buck2:
then it worked betterer.

 :)

waza04:
go wilko mate, pick up some caustic soda..... make a weak mix to start, then drop your bits in! blasts it off in seconds.  :daumenhoch:

crightonk:

--- Quote from: waza04 on February 22, 2011, 09:09 PM ---go wilko mate, pick up some caustic soda..... make a weak mix to start, then drop your bits in! blasts it off in seconds.  :daumenhoch:

--- End quote ---

I take my bits to work, there's a tank of caustic for cleaning turbine parts and as you say seconds and it's stripped, sorry that doesn't help you :-[

Navigation

[0] Message Index

[#] Next page

[*] Previous page