Technical & Reference Section > Tech and Restoration

chain lignment problem

<< < (2/2)

HEYWOOD BMX:
? Any pics? Normally there should be 2 x 2.5mm plastic BB spacers on the non-drive side and 1 x 2.5mm on the drive side.Also maybe 1 or 2 1mm axle washers between the ends of the BB bearing & the arms if needed.

Chinadog:
You used to get a freewheel spacer with some brands of power disk bitd, the ones where the chainring bolts to the outside face.

Maybe try a decent old type bike shop :-\

john4130:
you could try a thinner cone locknut on the freewheel side.

Bigplinky:
You tried running a powerdisc with the chainwheel on the inside Greg?

motomagII:

--- Quote from: Bigplinky on February 25, 2011, 05:31 PM ---You tried running a powerdisc with the chainwheel on the inside Greg?

--- End quote ---
they are 4 arm alloy shimano craqnks so only use a chainring as spider if fixed
 :daumenhoch:

Navigation

[0] Message Index

[*] Previous page