Technical & Reference Section > Tech and Restoration

extending bars

(1/3) > >>

motomagII:
is there any easy way extending bar width without welding please guys need inch or so on either end

waza04:
 :LolLolLolLol: you could sleave them, dont really seem worth it though for an inch.  :daumenhoch:

stfc:
Bluetack??     :)  welding surely would be the only way if your gonna ride it , If its for a show bike doweled wood machined on one end to slide inside the bars??

motomagII:
an inch makes a massive difference either side the bars are 24 wide as new.i ride bars at 28 but wanna try set at 26 as 28 is bit too wide for me
wanna get em rideablke at 26 see if they are okay if not then go for 27 etc etc

waza04:
make a couple of sleeves then mate, and add a little at a time till they feel right...... then i think you only safe bet would be to put the sleeve in and weld them up. grips would cover up any welds.  :daumenhoch:

Navigation

[0] Message Index

[#] Next page