Technical & Reference Section > Tech and Restoration

Getting BB cups in

<< < (7/8) > >>

Swivel:

--- Quote from: squigly on April 12, 2011, 01:17 PM ---
--- Quote from: Swivel on April 12, 2011, 01:11 PM ---All sorted now lads due to Shiner (darren) ta mate  :daumenhoch:

--- End quote ---

out of interest, what did you do  ?

--- End quote ---

Big fook off bolt and very big washers too instead the cups then tighten, was a fooker but went in eventually  :daumenhoch:

Gary72:
Should have given me a shout Matt, I normally use the vise at work for mine :daumenhoch:

animal:
When I bought my MRD Expert bitd had exactly the same prob  ::) never did change them cups after once  :2funny: kept em well greased and never needed 2, it was bad enough once when I was 13  :2funny:

WINI:
Any chance of borrowing the press guys?  Don't know who has it currently but happy to pay postage costs as my hammer is scared.

 :daumenhoch:

Clean:

--- Quote from: thewinsta on April 18, 2011, 07:59 PM ---Any chance of borrowing the press guys?  Don't know who has it currently but happy to pay postage costs as my hammer is scared.

 :daumenhoch:

--- End quote ---

Winsta,

I have one you can have at the end of the week.  :coolsmiley:

Give us a bell!  :daumenhoch:

Clean.

Navigation

[0] Message Index

[#] Next page

[*] Previous page