Technical & Reference Section > Tech and Restoration

potts mod help needed.......

<< < (2/3) > >>

bigfatolly:
Steve,i tell ya now mate,i had a tuf neck freestyle stem BITD with a dark blue clarks powerglide through it,they were all i could afford  :LolLolLolLol:

IT HAS TO WORK :tickedoff:

BENDYCAT ELEVENTEEN:
backing up what was said above

Clarkes cables are thicker than a standard cable






i have a few to check

Betty:
Early potts mod bolts were drilled just to take the inner cable through, use a lever stop against the bolt (above and below) or get it drilled out big enough to take the outer cable...  :daumenhoch:

john4130:
i always used powerglide cables bitd and there is a way of doing it. first thing to do is remove the teflon sleeve from inside the cable, then you have to cut the cable outer, measure from the lever to the top of the stem bolt as the cable would run then add a couple of inches and cut the outer. shave the plastic of the end a couple of inches and stick it in the stem bolt, then take the other half of the outer and shave off about 4 inches of plastic and sick that up the forks into the stem bolt. then insert the teflon inner through. then set up the brake as normal. it works a treat.  :daumenhoch:

oldtired:
fook me Bendy's  pm box just filled up  :LolLolLolLol: 

Navigation

[0] Message Index

[#] Next page

[*] Previous page