Technical & Reference Section > Tech and Restoration

redline twinpinch

(1/4) > >>

Gatters:
Just a quick question before I install the bb for the twin pinch ,there is a blue spacer, is this the correct size or do i need to trim this prior to fitting?

cheers

Phil

oh is for a streetbeat 85

MartyC:
Should already be the right size although some bb's do vary a little in width, it may leave one of the cups slightly proud of the BB, this is normal  :daumenhoch:

Gatters:
thx mate  :daumenhoch:

rick1970:
Hi i asked exacty the same question mate and was told to tap in the non sprocket side first so its flush then the sprocket side as it does sit slightly short by about 1.5 mm  :daumenhoch:

Gatters:

--- Quote from: rick1970 on July 13, 2011, 04:30 PM ---Hi i asked exacty the same question mate and was told to tap in the non sprocket side first so its flush then the sprocket side as it does sit slightly short by about 1.5 mm  :daumenhoch:

--- End quote ---

Yeah I done that, it does sit slightly proud not that you would see now its built up, feels a little tight, rotates nice and smooth thou but I guess that will ease with use, thx for advice  :daumenhoch:

Navigation

[0] Message Index

[#] Next page