Technical & Reference Section > Tech and Restoration

9/16 pedal...whats the Thread pitch?

<< < (2/2)

Gnarlyscoots:
If it's 20 TPI, then divide 20 threads by 25.4mm. That will give you the MM you need  :daumenhoch:

That works out 0.78mm per thread.

Not sure if that helps ya  :-\

steve69:

--- Quote from: Londonhellboy on August 07, 2011, 11:51 PM ---If it's 20 TPI, then divide 20 threads by 25.4mm. That will give you the MM you need  :daumenhoch:

That works out 0.78mm per thread.

Not sure if that helps ya  :-\


--- End quote ---
You won't be able to get m12 x 0.78 

It's NOT metric

The 'pitch' is 20 threads per inch (9/16" x 20tpi)

Gnarlyscoots:
French pedal spindles use M14 x 1.25 (14 mm/0.55 in metric diameter with 1.25 mm or 0.049 in pitch) threads, and thread loosely into a 9/16 pedal hole.

stidds:
You can also cut the correct threads for pedals on the heli-coil, I have a set of 9/16 pedal taps (left and right tap) that you can use if you need them.

Taipan:
thx stidds,maybe sorted,but if not i'll get back to you with your kind offer :daumenhoch:

Navigation

[0] Message Index

[*] Previous page