Technical & Reference Section > Tech and Restoration

scorpion brakedancer custom/resto

<< < (8/13) > >>

brakedancer:
this is my first potts mod so i hope its correct ?
the only problem i see is where the cable comes down the head tube and out the bottom....
might get some tyre rub !!!
what the best way to pull the cable in to get clearence ?

theRuler:

--- Quote from: brakedancer on September 01, 2011, 08:54 PM ---what the best way to pull the cable in to get clearence ?

--- End quote ---

Fat cable tie.

Oh and make sure the cable is the correct side of the brake bolt!

ukoldschool:
using a gyro is a good idea as you wont need that silly dual cable stop thingy on the lever, and you can use 2 regular rear brake cables to run to each individual rear brake.

brakedancer:
thats the plan ;) ;)

pickle:
also make sure you squirt a load of WD40 down the cable so it doesn't start to stick on the bend.

I'd also bung a washer under that stem bolt so you don't end up scratching the fook out of the gold anno  :daumenhoch:

Navigation

[0] Message Index

[#] Next page

[*] Previous page