Technical & Reference Section > Tech and Restoration

What takes it off ?

<< < (2/3) > >>

mattbloke:
The L.A.P.D. ?

BENDYCAT ELEVENTEEN:
had it in oven pride before - it was in for a hour and  and nothing - tried nitromors = nudda thang

don't think the gasket stuff is going to work DD

it's like a chemical way it has been put on - it's thin layer of baked on stuff ?

any one know  :'(

hunterdubber:
Is it an alloy headset or steel

If it's alloy it could be hard anno like on Pro class III rims well hard to remove , try caustic rather than Oven pride


If it's a steel headset  it could be a type of black chrome plate ,,, in which its take it to a chromers for stripping

Failing these ,,, have you tried sanding  it not too hard  :-\

or big chisels and angle grinding  :D

BENDYCAT ELEVENTEEN:
steel i think  :D ;D 

and i think you right mate - it's like a black chrome plate

i can stand there for hours on each piece on the polishing mop  ::) was just hoping there would be a quicker way with some chemical stuff  :'( ;D

 ;)

rad_pitt:

--- Quote from: BENDYCAT ELEVENTEEN on November 29, 2011, 11:45 PM ---steel i think  :D ;D 

and i think you right mate - it's like a black chrome plate

i can stand there for hours on each piece on the polishing mop  ::) was just hoping there would be a quicker way with some chemical stuff  :'( ;D

 ;)

--- End quote ---

I think it's stained Bendy.. Retro Rich on BW polished one up with some good results. Give him a nudge, he may be able to help mate  :daumenhoch:

Navigation

[0] Message Index

[#] Next page

[*] Previous page