Technical & Reference Section > Tech and Restoration

Dumb question??

<< < (3/5) > >>

sparky:
The company that manufactures Nitromors removed the 'dichloromethane' that gave it its strength, other brands had to go the same way because of a Health and Safety European directive. :knuppel2:

The new stuff is crap, as I found out myself.

Mdbh:
Right then next question with out getting blasted how can I get it raw with damaging the metal?I can imagen sanding will take ages

CustardLips:
Took my frame to a metal polishers and they stripped it for 45 quid.!

Peter J:
This stuff is very good  :daumenhoch:

http://www.ebay.co.uk/itm/280712339831'ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649

And you can re-use it again and again  :daumenhoch:

Helps a lot if the parts are warm (as if you were doing it in summer or in side)

I've also used the gasket stuff..........works on some frames but not on others  :-\

BMX1973:

Just a thought. What about putting the Nitromores on - then wrapping it in Clingfilm and leave it overnight, but dont let the Nitromores dry out?  :-\

Navigation

[0] Message Index

[#] Next page

[*] Previous page