Technical & Reference Section > Tech and Restoration

How to make resin moulds

<< < (2/4) > >>

snav69:
You do realise that DX end caps are threaded don't you  ???

No good just pressing it into resin just to make a flat disc  ::)

 :coolsmiley:

lk_97:
I was thinking of making a 2 part mould if that would work?

dordymush:
good that your trying to think up ways of earning a few quid at your age lucas  :daumenhoch:.
give it a go young un  :)

Dannywhac:
Can;t see why it wouldn't work using a two/three part mould - you'd just need to ensure that you had zero air bubbles around the finer detailing (like threads etc). :)

snav69:
2 piece should be Ok as you could unscrew it out the mould to leave a good enough impression  :daumenhoch:

Give it a go  :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page