Technical & Reference Section > Tech and Restoration
ACS Z Rim Decal Positions??
Retrodan72:
Alright lads is there a correct/scientific way method of fitting these?? :-\
Where's best to place the 1st and what's the best way to ensure you get equal spacing between them?? :coolsmiley:
Cheers Dan. :daumenhoch:
BENDYCAT ELEVENTEEN:
I'm sure there is a easy way but my brain being so powerful some times it over heats and doesn't always take the east route
I got string and went round the outside of the rim - them divide the length into three using my massive brain and a calculator - mark the three points on the string - then with a pencil i mark the spots on the wheels and measured the distance between each length to make sure it was in the middle and spot on - them measure the middle of the decal of stencil and find the middle - then it's a case of using you eye to find the height it should go at
hope you understand how i did it :D
cheers B ;)
Retrodan72:
--- Quote from: BENDYCAT ELEVENTEEN on March 10, 2012, 11:34 AM ---I'm sure there is a easy way but my brain being so powerful some times it over heats and doesn't always take the east route
I got string and went round the outside of the rim - them divide the length into three using my massive brain and a calculator - mark the three points on the string - then with a pencil i mark the spots on the wheels and measured the distance between each length to make sure it was in the middle and spot on - them measure the middle of the decal of stencil and find the middle - then it's a case of using you eye to find the height it should go at
hope you understand how i did it :D
cheers B ;)
--- End quote ---
Makes sense that B, good work. :daumenhoch:
BENDYCAT ELEVENTEEN:
??? well can you explain it to me now ! ???
Retrodan72:
--- Quote from: BENDYCAT ELEVENTEEN on March 10, 2012, 12:19 PM --- ??? well can you explain it to me now ! ???
--- End quote ---
No, but i'll have a go with the string. :daumenhoch:
Navigation
[0] Message Index
[#] Next page
Go to full version