Technical & Reference Section > Tech and Restoration

headset bearing cup

<< < (2/3) > >>

neil:
its a cruiser :daumenhoch:

Gary72:
It's not been dropped on it's headtube and out of round?

doctor-46:
i've always found they need hitting just a little harder than you think it needs!
lump of wood under other end of head tube, square up the cup, thin plank of wood on top and a good sharp whack should sort it.  :daumenhoch:

pkripster:
there crap really i had one  couldnt work out how it went even till  i striped another frAME dump it try an beartrap two tioga much simpler

Gish:
i always use a hammer to bray my cups in, it never fails  :D

Navigation

[0] Message Index

[#] Next page

[*] Previous page