Technical & Reference Section > Tech and Restoration

REDLINE CRANK FITMENT - HELP PLEASE!

<< < (2/2)

1982:
Cheers gents, will have a measure up at the weekend and go from there! :daumenhoch:

1982:

--- Quote from: Gary72 on April 04, 2012, 08:26 PM ---Buy the right size, You will never get the cut 100% straight

--- End quote ---



Good advice Gary!!
I carefully measured and cut it down, now its too freaking short by about 1mm :-X

Is the tube supposed to be a tight fit between the bearings to stop them imploding when you tighten the crank arm end bolts??
If not its ok, but if so then I need a new one :'(
Please help

Jaymz:
You should get away with 1mm, thats only 0.5mm each end and the bearings will push to that,

Navigation

[0] Message Index

[*] Previous page