Technical & Reference Section > Tech and Restoration

Shimano dx's

<< < (14/18) > >>

kev-s:
alex pm rakas or joe on here, to give em the worn look, rough em up on a brick wall and smear a bit of dirt and grease on em and wipe off :daumenhoch: :daumenhoch:

ED209:

--- Quote from: discostu on April 16, 2012, 03:56 PM ---You can't weld steel to alloy.  :daumenhoch:

Alloy melts at a much lower temperature against steel.

--- End quote ---

Nope.. you said "You can't weld steel to alloy" and you can  :laugh:

ED209:

--- Quote from: S&MAlex on April 17, 2012, 10:06 AM ---Enough about pins for a moment. Does anyone have any of the re-pop end caps? My pedals are OK but the end caps are mashed where I took them out to swap the spindles round for LHD  :crazy2:

Better still, does anyone have any used, but OK end caps? A brand new set would look a bit out of place on my used bodys

--- End quote ---

might be able to help you there Alex as I need a pukka new pair for my DX so can flow you the others I have if you thought they were good enough... will do a pic  :daumenhoch:

SaMAlex:

--- Quote from: ED209º on April 17, 2012, 10:10 AM ---might be able to help you there Alex as I need a pukka new pair for my DX so can flow you the others I have if you thought they were good enough... will do a pic  :daumenhoch:

--- End quote ---


I like the sound of that, thanks.  :daumenhoch:

Im sure we can work out some kind of a swap  ;)

ED209:
alex - will pm ya a pic in a sec  :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page