Technical & Reference Section > Tech and Restoration

Bearing Cups

(1/2) > >>

CustardLips:
What's the best way to fit the bearing cups in the head tube and the bottom bracket ?
I'm guessing 2 pieces of 3x2 and an hammer or will they need milling ?
Thanks.

Betty:

--- Quote from: CustardLips on April 22, 2012, 02:22 PM ---I'm guessing 2 pieces of 3x2 and an hammer

--- End quote ---

This  :daumenhoch:

CustardLips:
This  :daumenhoch:
[/quote]



Thought as much !  :daumenhoch:

punkdSICO:
A hammer works for sure but I have a large vice and I use this, ensuring there is no metal on metal contact using wooden spacers.

Works a dream but to be honest, you often still have to give them a few final whacks with a hammer if they are not 100% seated on one side..

Good luck!

Paul

whatquid:
ive always used two bits of wood and a hammer....bang bang bang..!!!! and they boys are in...boshhhhhhhh, no messin...!!!!

Navigation

[0] Message Index

[#] Next page