Technical & Reference Section > Tech and Restoration

Fancy a screw...?!

(1/2) > >>

Devilock:
Basically one of the screws on my XC II's has been slightly rounded off so what solutions do you lot have for removing the bastard?

WARDY:

animal:
Nice punch there Mikey  :daumenhoch:

I drill a small hole through the screw being very careful not 2 drill straight through the ally body aswell  ::) then hammer a tight fitting alley key into the hole and that should get it out by turning very carefully . Try and tighten it a little first as this normally cracks the stickyness  ;) 

Devilock:

--- Quote from: Wardy on April 25, 2012, 06:58 PM ---

--- End quote ---

 ;D Already tried that machine!!



--- Quote from: ANIMAL on April 25, 2012, 07:04 PM ---Nice punch there Mikey  :daumenhoch:

I drill a small hole through the screw being very careful not 2 drill straight through the ally body aswell  ::) then hammer a tight fitting alley key into the hole and that should get it out by turning very carefully . Try and tighten it a little first as this normally cracks the stickyness  ;) 

--- End quote ---


Cant tighten it as the head has been rounded off... Ill try the drill method...when I get a drill!!!  :D

BENDYCAT ELEVENTEEN:
Show pic  :knuppel2:

Navigation

[0] Message Index

[#] Next page