Technical & Reference Section > Tech and Restoration

890 - 1020

<< < (2/2)

meticulous:
the numbers refer to millimetres reach.

hunterdubber:
Gaz it's reach from the cetre fixing to the end of the brake block slots .

Same number refer to all breaks ,, that's why you need a MX1000 for a PK Ripper because a MX900 is too short to reach  :daumenhoch:

Spen69:
Yep, been through this a few times but an 890 measures 89mm from centre of spindle to centre of brake block in the furthest posititon. So a 1020 is 102mm, an MX1000 is 100mm and it also applies as you get smaller so a 610 is only 61mm (used for minis with 1-3/8" rims).

I've also had a few 1080's which I imagine would really help out out you Ripper builders..... Thinking about it, it was Ash who had them off me...... ;-)

Navigation

[0] Message Index

[*] Previous page