Technical & Reference Section > Tech and Restoration

restoring mx1000's

(1/2) > >>

benno:
Hi guys just stripped and painted my mx 1000's and put a new decal over the stamped dia compe bit ,
BUT now i want to paint in the MX bit anyone got any ideas the best way or is it a case of tiny brush and a steady hand
or a blue sharpie pen or the like  :)
cheers Benno

sid1972:
I use a paint pen, any that goes over the edges can be rubbed off. I then use clear varnish with a fine brush to seal it.

benno:
yeah gonna have a look at what size tips i can get sharpie's in ,
i was planning on laquering them after so that will seal it in
cheers Benno

bobbbbsy:
 :4_17_5:

 :LolLolLolLol:

sid1972:
your better off with a large flat nib and paint over the surface - rub the excess off when its been on a few minutes. Use the flat edge of a knife wrapped in a tight cloth. This leaves the paint in the recess.

hope that make sense.

Navigation

[0] Message Index

[#] Next page