Technical & Reference Section > Tech and Restoration

Rusted in pedals

(1/2) > >>

Clean:
OK, Radsters,

Easiest way to remove a pedal rusted into a 30 year old OPC?  ???

Currently looking at drilling the fooker out, which would be a shame as the pedals are a hand rider sale. :-\

Help, please?  :angel:

Thanks,  :daumenhoch:

Clean.   :coolsmiley:

Jaymz:
I got annoyed with destroying pedals just to get them out, In the end I invested in a proper long handled pedal spanner and a piece of pipe for leverage, try to tighten them first then pop those bad boys off, a quick soak in WD always helps too

Peter J:
WD-40 and Heat  :daumenhoch:

Done the same today Rich

bobbbbsy:

--- Quote from: Jaymz on May 27, 2012, 08:25 PM ---I got annoyed with destroying pedals just to get them out, In the end I invested in a proper long handled pedal spanner and a piece of pipe for leverage, try to tighten them first then pop those bad boys off, a quick soak in WD always helps too

--- End quote ---


 :daumenhoch:

this exactly.. wet , correct tool not a 15 mm spanner! tighten if poss to loosen ! are they in the bike- wheels? stand on one pedal on the floor one one side while you loosen the other!

stfc:
Rostoff from the motorist Centre , wd40 is pants ...Or plusgas if no Rostoff

Navigation

[0] Message Index

[#] Next page