Technical & Reference Section > Tech and Restoration
Spokes too long on wheel build..........
wildon:
i laced z's with low flange acs z hubs with 194's and they were fine ???
bigfatolly:
Well they are getting the dremel treatment anyway :4_17_5:
midschooljon:
If its only every 2nd spoke sticking out it means you need to rotate the spokes one hole back to even them out. Sometimes its one required on one side, but can happen on both. Pretty quick to do as you dont need to relace the wheel entirely.
bigfatolly:
I think its about every 4th spoke,i don't think i have done anything wrong as they look ok and the spin ok and arent buckled :daumenhoch:
midschooljon:
--- Quote from: bigfatolly on May 29, 2012, 10:55 PM ---I think its about every 4th spoke,i don't think i have done anything wrong as they look ok and the spin ok and arent buckled :daumenhoch:
--- End quote ---
If its every 4th spoke sticking out the top it just means one side needs to be rotated back one hole. Follow the sticking out spoke down to the flange to see which side it is. Then just undo the spokes 2 at a time (2 that cross each other) and move them back one hole working your way around the wheel. Once you undo the 2 spokes and slide them over you will see how they level out right away. :daumenhoch:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version