Technical & Reference Section > Tech and Restoration

Handle bars keep moving

<< < (2/2)

adeshere:
I really mean that the stem moves

MartyC:
I had this problem with a set of Haro Vectors bitd, to get around it I increased the height of the stem in the forks by about a half an inch as I found that the pressure of the stem bolt/wedge had caused the forks to either expand slightly or they wore into the forks at that point just enough to allow the stem to twist even though it was as tight as it was ever going to be.  Try lowering or raising your stem a touch and see if that helps, raising it and using a flex fighter might be the way to go.

Marty  :daumenhoch:

Navigation

[0] Message Index

[*] Previous page