Technical & Reference Section > Tech and Restoration

Cut down bars

<< < (2/2)

Gizmo:
thanks for the tips guys
Appreciated ;)
ill give the copper a go if not ill pm
the radster thx :)

ED209:
Pics of Phil's work on my Hoffman bars  :smitten:

pickle:

--- Quote from: gizmo on August 05, 2012, 06:07 PM --- Hi got some bars which have been cut down , bout 1" off each side
Is there anything that can be done to get the right width again ?
Thanks  ;)

--- End quote ---

I guess the answer is yes, but what is 'the right width'?  1" off each side isn't that much to be honest and hardly noticable, unless the bars were very narrow to start with.

what bars are they?  ???

Gizmo:

--- Quote from: ED209º on August 05, 2012, 11:16 PM ---Pics of Phil's work on my Hoffman bars  :smitten:







--- End quote ---

amazing job there , imm gona pm him
for a price :) thanks

Gizmo:

--- Quote from: pickle on August 06, 2012, 09:39 AM ---
--- Quote from: gizmo on August 05, 2012, 06:07 PM --- Hi got some bars which have been cut down , bout 1" off each side
Is there anything that can be done to get the right width again ?
Thanks  ;)

--- End quote ---

I guess the answer is yes, but what is 'the right width'?  1" off each side isn't that much to be honest and hardly noticable, unless the bars were very narrow to start with.

what bars are they?  ???

--- End quote ---

there db pro bars , bit uncomforatable
To ride cut down

Navigation

[0] Message Index

[*] Previous page