Technical & Reference Section > Tech and Restoration

Something I'm dlcking with :: Kinda BMX!!

<< < (3/7) > >>

Badbaldie:

--- Quote from: Darren K.A.P on September 01, 2012, 09:43 PM ---
--- Quote from: dan-dare on September 01, 2012, 07:13 PM ---  ::)

--- End quote ---

   Jaymz when did you pose for the pic  :LolLolLolLol: :LolLolLolLol:

--- End quote ---

hope your not thinking of sitting on this Kappy after that plate of chips  :LolLolLolLol: :2funny: :LolLolLolLol: :2funny:

Jaymz:

--- Quote from: Darren K.A.P on September 01, 2012, 09:43 PM ---
--- Quote from: dan-dare on September 01, 2012, 07:13 PM ---  ::)

--- End quote ---

   Jaymz when did you pose for the pic  :LolLolLolLol: :LolLolLolLol:

--- End quote ---
Its a fresh one in my portfolio fella, had it done last week


--- Quote from: Londonhellboy on September 01, 2012, 09:27 PM ---Jaymz, let the rear tyres down a bit, measure the radius and get some large plastic waste pipe. Cut to size, place over the tyres and pump them up again  :daumenhoch:

--- End quote ---
Dude you are a legend  :daumenhoch:

GaryN:
Jaymz, a thought for the front wheel/cranks -

How about seeing if you can lay your hands on a Tuff wheel and a single piece BMX crank and see if the pair might somehow go together although the fork dropouts will also need modifying as well.

Just a thought and without actually having the parts to look at it might be a rubbish idea  :idiot2:

Jaymz:

--- Quote from: GaryN on September 01, 2012, 10:43 PM ---Jaymz, a thought for the front wheel/cranks -

How about seeing if you can lay your hands on a Tuff wheel and a single piece BMX crank and see if the pair might somehow go together although the fork dropouts will also need modifying as well.

Just a thought and without actually having the parts to look at it might be a rubbish idea  :idiot2:



--- End quote ---
that had come to mind.
My idea at the moment is to use a cheap 3piece kiddy crank machined so its all one diameter. Then sleeve it.
The fork dropouts will be modded to look like the top of a primo rod seat post

It's hard to explain. But in my head its sorted. You'll have to wait for pics

GaryN:
I get where you're coming from.

Navigation

[0] Message Index

[#] Next page

[*] Previous page