Technical & Reference Section > Tech and Restoration

cyclecraft info

<< < (2/3) > >>

kurtallen46gp2009:
top tube is 19 and a half inches ....... headtube 3.9 inches ........
seat tube length to top of BB nearly 10 inches
top tube thickness 3 inches ......... bottom tube thickness 4.5 inches
rear seat stays [top] 14.5 inches ........... rear seat stays [bottom] 12.6 inches [these are tube lengths]

oldtired:
unusual decals for a cc too ?     are these the rims you wanted the valve hole size for?  if so don't do it get some presta tubes  :daumenhoch:

kurtallen46gp2009:
the decals are not original thats how i got the CC
yes its me what asked about drilling the rims . i wont drill them [phew]
their ukai 20 x 1and 1/8 with raleigh record tyres  :)

rooski:

--- Quote from: kurtallen46gp2009 on October 10, 2012, 10:17 PM ---top tube is 19 and a half inches ....... headtube 3.9 inches ........
seat tube length to top of BB nearly 10 inches
top tube thickness 3 inches ......... bottom tube thickness 4.5 inches
rear seat stays [top] 14.5 inches ........... rear seat stays [bottom] 12.6 inches [these are tube lengths]

--- End quote ---

Could be an expert size frame,judging by those measurements,and the angle of the seat tube,was the tt measured centre to centre ???

Whats the down tube length cr of bb to cr of headtube ???

May be able to measure one of the frames i have to compare :daumenhoch:

kurtallen46gp2009:
the top tube was measured centre to centre
bottom tube cr to cr is 19inches  :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page