Technical & Reference Section > Tech and Restoration

BAR EXTENDERS - Do they exist ?

<< < (3/3)

Glynnyboy:
 :shocked: cutting holes in os grips ?

CustardLips:

--- Quote from: glynnyboy on November 09, 2012, 10:51 PM --- :shocked: cutting holes in os grips ?

--- End quote ---
Yeah, i agree. Big No No !  :idiot2:

GavinDavis:
If your using o/s grips then you could either cut the end flange off by hand, or turn it down in a lathe.  Either way would work as the grubb screw is still visible to be able to clamp it to the inside of the bars :)

When you put your o/s grips over the top of the extensions you wouldnt be able to tell any difference compared to the end of a normal bar :)

Job done....Slight bit of a modification to the extensions but it would definitely work.

gib66:
all i need now is these being 2 inch either side instead of inch

GavinDavis:
What bars are you using?  Are they already cut cos you could always source the original size ones?  Or....if all else fails....bring on the welder :)

Navigation

[0] Message Index

[*] Previous page