Technical & Reference Section > Tech and Restoration

Vector potts mod

<< < (2/2)

splodge:

--- Quote from: john4130 on November 08, 2012, 05:10 PM ---i had one bitd, think it was an acs.  powerglide cables were the best for this as you could remove the teflon inner first before cutting then stick it back in once it was fitted.

--- End quote ---

Yes your right, I found the acs bolts were made from really soft metal & as soon as you tighten them up they would strip the threads. If you tried to do it as tight without stripping then the stem wasnt tight enough & the first tail whip you try would twist the stem in the forks. I went through two bolts then the shop just gave me my money back.

not johndub71:
Drill the top bit to accept a better hollow bolt, or, find a supstitution part to do the job. Post a pic up fo where the stem bolt goes through.

Navigation

[0] Message Index

[*] Previous page