BMX General > BMX Chat
Anniversary frameset already on ebay
sparky:
--- Quote from: kungfunky on November 08, 2012, 06:01 PM ---Is it just me or does the weld at the rear of the seat mast look hmmmmmmmmmmm a little rough ?.. could just be the pic on my phone.
--- End quote ---
That's normal for Taiwanese welding. :daumenhoch:
rad_pitt:
--- Quote from: kungfunky on November 08, 2012, 06:01 PM ---Is it just me or does the weld at the rear of the seat mast look hmmmmmmmmmmm a little rough ?.. could just be the pic on my phone.
--- End quote ---
No, it looks the same on my laptop :daumenhoch:
They're smart looking things, especially in that display box - I just couldn't justify it to keep it as such, a display piece.
kungfunky:
so it's not my pone after all then ???
dordymush:
i dont think the reflections helps on that pic but there is a big ole blob there :crazy2:
Dark Diggler:
--- Quote from: sparky on November 08, 2012, 06:14 PM ---
--- Quote from: kungfunky on November 08, 2012, 06:01 PM ---Is it just me or does the weld at the rear of the seat mast look hmmmmmmmmmmm a little rough ?.. could just be the pic on my phone.
--- End quote ---
That's normal for Taiwanese welding. :daumenhoch:
--- End quote ---
Cheap Taiwan welding from the eighties maybe, have a look at some Dialled frames, the welding is consistently fantastic, its not the country that a frame is made in that makes it great, its the design, materials, process and most importantly, quality control. A good example of this would be the profile anniversary box cranks, I have never seen such poor welding, on more than a few sets and they were made in the USA by profile....As a result, to me, they look a bit shit
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version