Technical & Reference Section > Tech and Restoration
Show us your TOOL - thread - tools that work for BMX restoring
BENDYCAT ELEVENTEEN:
How does it work ?
john4130:
lace up the wheel with just a couple of turns on the nipples, once laced stick the tool in from the top of the nipples and tighten till it bottoms out. go round the whole wheel doing this. this ensures all the nipples have the same amount of turns. then it,s just a case of tensioning the wheel. i,ve used this loads and the wheel needs very little truing afterwards.
OrgasmDonor:
--- Quote from: BENDYCAT ELEVENTEEN on November 12, 2012, 03:50 PM ---well thank you oldtired mate - yup shame we couldn't get a decent thread about tools and not just tools repleying ::) ;D
see how it goes and maybe it could be cleaned up after ;)
--- End quote ---
sorry, grinders are a tool for men, will one of these do ya
ideal for getting chalk the right consistency for preventing freshly applied puncture patches from sticking to the inside of your tyres :daumenhoch: :LolLolLolLol:
ED209:
--- Quote from: OrgasmDonor on November 12, 2012, 03:02 PM ---had trouble getting the gungy stuff left by the headtube decal on my Hawk F20 f/f, so it was time for my trusty decal remover :daumenhoch:
--- End quote ---
x2 thats my tool right there :4_17_5:
stidds:
--- Quote from: oldtired on November 12, 2012, 03:33 PM ---suggested a similar idea a bit back , fell upon deaf ears back then :( , maybe you got more clout with the mods B :daumenhoch: ,and have better luck tis a good idea threads keep popping up on how do get this part off, or on , be a good ref for people new to building , plus could include some of the home made tools that work , the wheel jig that did the rounds is a great example :daumenhoch:
http://www.radbmx.co.uk/forum/index.php'topic=123488.0
--- End quote ---
Why would you have to have any clout with the moderators for people to reply to a thread? Yours fell on deaf ears, it happens.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version