Technical & Reference Section > Tech and Restoration

wobbly aero zytec

<< < (2/3) > >>

animal:
check the spindle isn't bent  ;)

Dannywhac:
If it's not the spindle, here's the link to the press idea:

http://bmxmuseum.com/forums/viewtopic.php?id=58417

Failing that you can mount them to a set of forks, and using laggy bands around the fork legs and around the buckle try and pull them back over time.

Never tried it meself.

not johndub71:
Wouldnt warming them up help them relax back into shape? OK, heat the wheel up while in a fork so you could see the buckle. Fancy hair dryer with a cold blast button would be best. Heat the wheel up from hub upwards to buckled section, give it a bit of pursuation into place while heating it up, then if straight, blast it cold to set it's position. Worth a try.

chubby:

--- Quote from: ANIMAL on November 14, 2012, 06:21 PM ---check the spindle isn't bent  ;)

--- End quote ---
never checked that  :uglystupid2: I've got a set i know are ok
Will pop it in n see thanks mate

BENDYCAT ELEVENTEEN:
If the hubs are not tightened up right, they can have a little wobble

but i have found that they were made a bit like that, and have a wobble in them from the start - some are good and some are... just bad with a wobble  :D

Navigation

[0] Message Index

[#] Next page

[*] Previous page