BMX General > BMX Chat

ACE racing frame and forks

<< < (3/7) > >>

58 delray:

--- Quote from: Peter J on December 06, 2012, 07:19 PM ---Look a bit Hutch

But the bottom on the fork legs looks flat cut

Its just the location of the plate at the bottom of the legs looks in the same position


Or Patty

http://bmxmuseum.com/forums/viewtopic.php?id=272806


--- End quote ---

not patty as the dropouts are below the main part of the leg and the wrong shape for hutch  :-\

58 delray:

--- Quote from: dan-dare on December 06, 2012, 07:26 PM ---mongoose

--- End quote ---

if you mean supergoose then i would say the legs look to fat for that  :-\

Peter J:
http://www.radbmx.co.uk/forum/index.php'topic=116143.0

 :-\

58 delray:

--- Quote from: Peter J on December 06, 2012, 07:30 PM ---http://www.radbmx.co.uk/forum/index.php'topic=116143.0

 :-\

--- End quote ---

i think they were too late tbh as i dont remember them being around in 81 but closer in looks mate  :daumenhoch:

RATTY:
Richard Barrington had the frames built in the far East, I remember them being wall to wall in the shop when they arrived. I would think that someone like Akisu would have been the builder, so it would make sense that they were Akisu forks. Possibly slightly different, depending on the spec at the time.

Navigation

[0] Message Index

[#] Next page

[*] Previous page